My build

[Speezles]

I'm new here and I was wondering if some of you could take a look at my wishlist and see if there's anything I need/don't need. Thank you!

http://www.thecustomsabershop.com/Vi...shlistId=30675

[Silver Serpent]

You're probably going to want a recharge port, unless you plan on removing the battery pack to recharge it. Pick up a few extra JST connectors to help hook up your battery pack and LED module in any case.

The 3.7v pack is not enough voltage to run the buckpuck. You should use a resistor instead. See the link in my signature for a resistor calculator.

Swap your momentary switch for a latching switch, or you will need to hold down the button to keep the saber on.

[Speezles]

Would you suggest a resistor or a stronger battery voltage?

[Silver Serpent]

For a simple saber without sound? I'd go with a resistor. It's cheaper and simpler to wire up.

[Forgetful Jedi Knight]

For a simple saber without sound? I'd go with a resistor. It's cheaper and simpler to wire up.

I agree completely.