Hey everyone,

My first build, after reading for 2 months. Following the Noob! So You Wanna Build A MHS Saber Huh? tutorial, I want to order the following, but have some questions...

Blade Holder #22
Retention Screw
7" Fluted with Guarded Style Switch Hole
Pommel Style 3, v1
MPS clip
MPS insert 13
Seoul P4 LED & MHS heatsink Module (Green)
Corbin Style Blade, 36"
Momentary Guarded switch
MHS choke style 3

I have a tap and die set, wiring, tubing, solder, eye protection and 3rd hand soldering station from my other hobby.

My main concern with with powering the saber. I have two 3.7v 2600mAH rechargable lithium cells (18650). I can pick up a wired holder at my local shop. Using the LED wizard, I found that if I used one cell with this setup, I would need a 1 ohm resistor. (brown black gold)

The P4 says 1000mAH max. I really dont want to pop anyting, but I would think that the resistor would prevent this. Anyone concur?

I use LEDs all the time in my HO scale train hobby, but I don't use batteries. I usually use track power.

Thanks for looking and any helpful hints.

DeckRoid