So I am going to start orderong parts for my saber next week. And I need to know something
Will the Ultrasabers MLS wired for FOC fit inside the v-grovved ribbed section?
So I am going to start orderong parts for my saber next week. And I need to know something
Will the Ultrasabers MLS wired for FOC fit inside the v-grovved ribbed section?
ABANDON ALL HOPE, YE WHO ENTER HERE!
Canto III of Dante's Inferno
Beware the Power of The Pope!
You'll have to ask over on the US forums. If you already have the components in your hand, get a set of calipers and measure them. Inner Diameter of the V-Grooved Ribbed section is 1.15".
We all have to start somewhere. The journey is all the more impressive by our humble beginnings.
http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!
I have asked. But no one responded. I just dont want to drop $70 on a mls unit just to find out it dont fit ya know?
ABANDON ALL HOPE, YE WHO ENTER HERE!
Canto III of Dante's Inferno
Beware the Power of The Pope!
Either the Nano Biscotte or the Petit Crouton from the TCSS store will fit in that section. The NB is the cheaper solution, but it does not support FoC, and is currently out of stock. The PC is a more expensive option, but it does provide FoC capabilities, plus a fair number of other features. Both boards are an excellent value, and I would recommend them to anyone wanting to add sound to their saber.
We generally avoid discussing US products on this site.
We all have to start somewhere. The journey is all the more impressive by our humble beginnings.
http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!
TCSS MODERATOR
All n00bs READ these first (PLEASE)!!!:
1. Forum Guidelines
2. FJK’s “Down and Dirty” guide to Ohm’s Law
"Yeah, yeah, I've heard it all before... you want blindingly bright, super loud, running 1138 blinkies off of the cheapest sound card you can find AND you want all of it to run on a battery the size of a dime, and run for a very, VERY long time. That one cracks me up every time..."
My email: fjk_tcss@yahoo.com
Got a question? Start Here. Have you tried the Thread Index yet? Most questions can be answered there.
I have both Led units, and the TCSS ones are much better suited to MHS parts. But that beinng said the others are small in diameter and could be used in tighter spaces. But by and far TCSS all the way!
It does take a bit of study and practice, but even I was able to get an LED Engin 10W RGBW hooked up. If you're looking at a single-channel LED, then that'll be even easier. Time, patience, and the right approach are the first three tools you'll need.
Bookmarks