Quote Originally Posted by Xevious View Post
That switch is long and that bezel looks short. I was going to ask if your HS tubes on the switch solder points were adequately isolating the contacts from the body.
I had heatshrink on the switch LED + side because i soldered the resistor to the prong, however i didn't do the negative side. I put a layer of electrical tape over the prongs before insertion into the body, however i have a feeling when i tightened the switch down it penetrated the tape.

My real question is why the hell the negative battery post on the recharge port is making contact with the pommel. Could this be a defect or is it by design?