D-ring hole size and mps insert style 7 hole size
Ok Trying to wrap up my order and I am all but stuck on this last bit of info.
What is the hole size in the D-ring?
What is the hole size in the MPS insert style 7?
What I want to know is what size screw I will need.
Yes 1 screw is holding up my order.
Please let me know so I can spend some money.
Thanks!!
Female Twi'leks are so Hot! I want one. Gotta love the lekku =0)~
Why not get MPS insert style 12? The D-ring is built in.
The holes in Insert 7 are not threaded in any case. You'd need to thread them yourself with a tap.
We all have to start somewhere. The journey is all the more impressive by our humble beginnings.
http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!
Not sure if you placed your order yet or not, but i've found that the 10-32 button head screws work well with the D-ring. The holes in Insert 7 definitely won't be big enough though; you'll have to do some drilling and tapping if you're set on going that route.
--------------------------Cadence--------------------------
Ok thanks. Wasn't sure if the 8-32 or the 10-32 would be big enough for the whole in the D-ring.
I don't care for the bulkiness of number 12 and I only have $99.25 on the card to spend for this and with adding that last screw I am at $99.23 including shipping.
Thanks again!!
Female Twi'leks are so Hot! I want one. Gotta love the lekku =0)~
Posting Permissions
Reply With Quote
Bookmarks