Hello,
I've been browsing on the forums reading on building a saber for months. I have a 2010 Hasbro Obi-Wan saber that I'll grab the soundboard from and plan on using the attached wiring diagram.
------------------------------------------------------------
HILT ELECTRONICS
------------------------------------------------------------
LED
•*Luxeon Rebel Star (Blue) <I'm assuming this is the Lux V because of the 700mA @3.4v)
http://www.thecustomsabershop.com/Lu...Star-P523.aspx
•*3.3ohm 5w resistor < correct? >
• Luxeon Rebel lens holder
•*Star thermal tape pad
• Heat sink shim for Rebel Stars
•*Luxeon collimator lens 8.7º viewing angle
SOUND
• 2010 Obi-Wan Hasbro soundboard
•*(2) swing sensors
• (1) clash sensor
•*MHS speaker mount V2
• Premium speaker
POWER
• 6AA battery holder (will use standard AAs for 9v)
•*Premium 9v connector
MISC
•*2ft. dual 18 gauge wire
•*3/32" heatshrink
•*NEED TO GET: TIP42 PNP type transistor
------------------------------------------------------------
SWITCHES:
------------------------------------------------------------
• Push on / off switch with black button
• Black rubber switch boot
------------------------------------------------------------
BLADE
------------------------------------------------------------
•*LED "Corbin Style" show blade, 1" OD 36"
•*8/32 x 3/8" aluminum thumb screw
• Drill and tap service for thumbscrew
------------------------------------------------------------
HILT from pommel to blade holder
------------------------------------------------------------
• MPS insert style #1
• MPS clip
•*MPS pommel style #3v2
• 3" fluted double female threaded connector (PC Flat Black)
•*MHS ribbed extension v-grooved (PC Flat Black)
• MHS choke style #3 (6 holes drilled around midsection)
• Blade holder style #17
Thanks for taking a look and excited to be joining the community.
- J
*
Bookmarks