I belive this is the right place seening how it deals with the boards. I have searched and searched for pics and Ideas but I need some pics. How do I keep my internals from moving. please help.
I belive this is the right place seening how it deals with the boards. I have searched and searched for pics and Ideas but I need some pics. How do I keep my internals from moving. please help.
Attach the board on top of your battery pack and secure the battery pack using MPS Speaker holder.
Other than that, heatshrink the board, and improvise.
Good luck.
I use a washer and rod setup the majority of the time. Unless I dont have space...
This chasis is made using Nylon washers, nuts, and spacers I found at ACE. It took about two hours to make.
The board is heatshrunk to the chasis after all wiring is tested and routed...
Hope that helped some...
Got a Question? There's a thread for that...
~Do what you can, with what you have, where you are.~Teddy Roosevelt
SollusVir everywhere else... FXsabers, Youtube, etc...
Bookmarks