This to my knowledge is the first ever Darth Nihl saber. It was sculpted by hand using a two part plumbing epoxy propoxy20. Not only is it Nihl's saber, but it has a Darth Talon end cap, if you would rather have either of Darth Krayt's Hands (Darth Nihl/Darth Talon). Sounds vents are on the underside of the hilt, opposite the AV switch and and inch down. The hilt took about a week to sculpt, and a few days in the shop to paint and complete the electronics. I started this just before the new year, and it is finally done. ;D I hope you enjoy.

Specs:
1" Copper pipe base
3/4" End cap Led assembly
5W Red Ledengine
FX Yoda Board
Short AV red
Pololu board
3W rectangle speaker
Recharge port in pommel (inside)
3.7V 18650 Li-ion
Nearly everything inside is able to be removed, and replaced. (gold bullet plugs)
11.5" Darth Talon Saber, 35" Darth Nihl Saber all together.
INTERCHANGEABLE END CAPS FOR EITHER NIHL, OR DARTH TALON

Pics:





Video:
http://s1020.photobucket.com/albums/...t=DSCF0027.mp4

Sorry for the video quality. My camera does not like doing videos. It will look a bit fuzzy, and the red will look yellow/orange in the video.