Awesome gift. The force tells me your sis will appreciate all the time you put into this build.
Awesome gift. The force tells me your sis will appreciate all the time you put into this build.
Skott said it right.
That's the best non-graflex graflex that I've ever seen!
I've seen a few of these done based on a pattern. I do believe this is probably the best one I've seen yet as well, even though others have actually made a fake clamp from scratch. It's one part worth investing in for sure because the clamps didn't look too good.
I cut the sink tube too high. Basically, I laid out the tube based upon the Reflex pattern, then mis-measured the tube midpoint from the top of the emitter curve instead of the bottom. Thus the cut to make the two tube "halves" ended up being about 3/4" to 1" too high. In retrospect, I should have measured the grips and clamp from the bottom to determine the cut line.
Last edited by Orthus; 01-05-2011 at 10:41 PM. Reason: grammar
ITs not bad tbh, the perportions actually look right where as the origional graflex looked off to me aswell.
Any intelligent fool can make things bigger and more complex. - Albert Einstein
Reaganomics not Obamanomics
Bookmarks