first off, i'm not that new to soldering or electronics, i just don't use my knowledge but once every couple years. i've looked at several solutions for power; to include 6 AA NiMH rechargables that likely wouldn't fit well, 8.4 and 7.2V battery packs with similar fit issues, and a small pair of Lithium Ion 3.7 V AA batteries charged externally. i think i've decided on the latter option.
the length is longer than what i gather is normal, but that's just how i want it. just over 14 inches and completely backwards. ^_^ i've attached a picture of it and the wiring diagram i threw together. i want to have the main pieces media blasted and i plan on putting a thin twisted cloth wrap over the fluted part of the main handle.
^_^ here's the parts list then. thanks!
7" Fluted with guarded style switch hole
Ribbed grooved / Choke Combo
Screw on LED blade holder style 14
MPS Pommel style 3 v2
Machined button for Covertec clip
1-3/16" ID Black O-ring
MPS Clip
Covertec Clip
8-32 x 1/4" socket head
Bezel for illuminated switches
MPS Insert style 3
DPDT Latching blue illuminated switch
8-32 x 3/8" aluminum thumb screw
8-32 x 3/8" Red Acetal thumb screw
220ohm 1/4w resistor
TrustFire Protected 3.7V 2400mAh 18650 Lithium Battery (2-pack)
---does anyone know of a battery holder for these?
2.1mm Power Jack
2.1mm plug adapter for smart charger
3.7V-14.8V Li-Ion Smart charger
Adjustable LED driver
Seoul P4 (White)
Power jack kill plug
Luxeon Collimator Lens 5 deg viewing angle
Luxeon III/P4 Lens Holder
Media blasting all parts
that's it then. ^_^ what does everyone think?
Bookmarks