-
-
-
Thanks for such a speedy reply! =D
I've already gotten a blue Luxeon V luckily so that's not a problem. So all i'll need to do is buy THIS and fit it into THIS and i'm good to go with the TCSS blades? I can do all the other parts myself though i was just confused on putting a blade into the flash replica.
Thanks again =D
-
-
I most certainly will! Thanks again for the info Rafalema! ^_^
-
-
Don't know if you've begun with your Graflex project yet but I wanted to give my 2 cents worth. First, I think you'll find there is a lot of room in the graflex for all your parts. Most people fit a small tactile switch under the red button(so when you press the red button it engages the tactile). That's not necessarily a difficult job but it does require some care. I noticed the Graflex LED blade holder is out of stock. If you want to wait that's fine. I can direct you to another source if you send me a pm though. Tearing down the Graflex to get it ready for conversion isn't difficult either. While you're ordering your Graflex from TCSS put in for a couple of the SPST momentary tactile switches too(short red plunger model).
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks