finding someone to anodize the inside instead of doing a PC would solve your problem
Type: Posts; User: ishtob
finding someone to anodize the inside instead of doing a PC would solve your problem
You might want to consider using a 7.4V battery. Crossguard sabers will use a minimum of 3 LEDs, each requiring ~3v. Yes you could wire them in parallel to keep the voltage requirements under 3.7v,...
what's the current you want to run your white on? I am calculating 3.7ohm
try the cree XP-L , runs roughly at the same brightness as 2 rebel whites, and could be brighter if you want to extend it past 2000ma
here's my Cree XP-L running at 2400ma in broad day light (my...
how much heat would be produced wiht a 6v regulator?
well.. my li-ion battery is a pack, and i go the charger for it too, just didn't want to have to get another changer.
what is the cap for?
planning on using a 5v 1.5A voltage regulator for the economy sound board. My current setup is 7.2V li-ion battery pack. How much heat would be generated from this step down? should I bother with a...
im not sure if it will drive a buckpuck... it might not be designed for that amount of current
Form II: Makashi
After Form I's proliferation as a saber combat technique, Form II or "Way of the Ysalamiri," came about as a means of lightsaber-to-lightsaber combat. It is described as being...
how do i remove the little pin on th epoly carbonate blade?
this one:
http://www.thecustomsabershop.com/sabers/scripts/05vader/16.jpg
I just recently heard of these Luxeon K2, which are supposably brighter and generates less heat, cant really find much informations on it and have no idea where to find retails that sells it, anyone...
hm... mine is only ike 2-3 inches into the hilt, and the electronics kinda gets in the way of the luxeon + optics
can you take some pics of its inside after u modify it? so that we can see how to...
use a small screw driver (the flat kind) and carefully, but firmly ply it out, be careful not to detach the metal cap from the plstic thing that is glued to the switch, because if you do, it would...
Name: Andy Chang
Age: 17
Occupation: High school senior
Location: Fremont California
Alias: Hsi-An
Force Affiliation: Jedi Lightsaber smith Apprentice
*waves to suit_man* here!! high school...
here's my sabers, and im proud to say that i got most of the parts from the custom saber shop [:D]
EL blade:
http://i6.photobucket.com/albums/y222/icbob/saber-sam.jpg...
oooo..... oil... i see i see
i bought a couple of the EL blade holders from the custom saber shop, the roblem is that the aluminum seems to be harder then my tap drills, i've already broken 3 drills and ruining 1 of the holder....
you can have custom saber shop do the conversion then purchase one of those 1/8' walled polycarbonate tubes and a clear tip, you do need to look for a defuser yourself.
this will make it many...
if you dont want to make a removable blade, the easiest thing to do is cut off some of the defuser (about 2 in) and then stick you luxeon with it's optics into the balde it sef, you will have to...
i hav emodded a mace, there wasnt enough room to make a removable assembly unless i take otu the sound and clash board, but i didnt, mine is now modded with non-removable blade....
ou can resolder them, but it might be easier jsut to get another blade and not duel with it, keep the broken one to wack ppl with