Activity Stream

Order them at the same time and we will make sure they fit.. order them separate and there is a chance they wont.

I recently ordered a trans-white 7/8" blade and asked for them to ship it with 1" thick walled diffuser in it. It fit for me.

Welcome to everyone! Can hardly wait to perceive what you think of. TCSS is an incredible spot to figure out how to build your sabers!

Hi EveryOne, Welcome to the Forum. Have the best environment for conversations with each other. thanks for it.

If you're talking about using the second red button on the bottom of the saber, you will have to dremel in a wire channel for it. I don't think you...

Hey thanks. Yes it is, with some brass cut to fit ( and glued into ) the slots.

The last two days, i reconsidered everything a little after your tips and arguments. I think i will stick with the Knight Chassis and one battery...

Thanks, all! I was flirting with brighter colors in the past year, and was tinkering with various emitter shroud designs. The idea hit me while I was...

Welcome!

Wow, awesome saber! Is that the claw mount from tcss shop?

A really nice and unique pair.

Welcome! I always like seeing new sabers.

I had to remove the rabbit ears to get the switch 22 in. Its tough. If you're building ANH version, then you can't put the aux switch where the...

Alright, will keep that in mind when i start to build everything up. Actually, i am not 100% sure what i will go for. I have seen the "Lets...

Wonderful job action. I also really like it. The sound was really so great and blowing. I watched it on my personal mobile phone and abide it very...

Nice Post. Wonderful conversation to solve a question.

I have used the 10A and 15A high drain 18650 batteries from TCSS. The 5A just refers to the shutoff ampload in the protection circuit. 5A isn't...

Mount your neopixel hilt adapter as close to your battery as you can get it (if your battery is in the chassis). If you're following the "Lets Build...

Tom/jbkuma - truly appreciate the tips, and am stepping through each suggestion. I just finished wiring up a new Prism 5.5 outside of the saber, and...

It's not a lost cause, but you're in for a bit of work. Do a Google search for a "cylinder hone" and you'll find a tool that can help you increase...

Is your saber still open or is everything locked away? There are a few things you can do to eliminate confounding factors and make sure each part is...

Thanks Tom, I really appreciate the guidance....strips from from TCSS, and I followed Madcow's TCSS video, so the strip wires are twisted to seat...

Where did you get your strips, and which ones are you using? Did you twist your data wire around your positive and negative in blade? DO not twist...

So I took apart the blade and cleaned and resoldered all connections after cutting and retwisting all wires. I reconnected the smd resistor and...

Thanks Tom - that certainly seems reasonable - I will try cleaning the LS pad and re-soldering the data line to the board since I experienced the...

Clean data pads, clear them of flux. You have corrupted data or bad strips. I have found that leftover flux will cause massive data corruption. ...