Wiring it with the blade would be cool! I usually follow this wiring guide the only difference being that the power indicator and the switch are one piece. Would I just connect the second LED to the...
Type: Posts; User: kingcobra5352
Wiring it with the blade would be cool! I usually follow this wiring guide the only difference being that the power indicator and the switch are one piece. Would I just connect the second LED to the...
Currently I have an illuminated switch on my saber but would like to add something like this as well. Is that possible with the NBv3/4?
Using the nano biscotte v4. I was always told to round up the voltage of the power source since a full charge 3.7v battery is closer to 4v. Is that not correct?
So I'm doing a build with a RRW tri cree LED. If my calculations are correct I need a 1.5ohm 1.5w resistor for the reds but the only one the shop has are 1.5ohm 5w. I know these should work but they...
Is adding heat shrink to the bare wire an option? I'm always worried that I'm going to melt the outside of the wire.
I have a shipment of speakers on the way that should be here tomorrow. If resoldering this speaker doesn't work, I will try a new one. Just seems kind of weird for a brand new speaker to die in less...
I pulled the wires away and tried it. Still the same issue.
I appreciate your reply. When you say the amp could be going, what would cause that?
Someone else pointed out that my solder points on the board could be too exposed. Though, when I take out the...
I recently completed my first build with a NBv4 in an Epoch saber. Everything was going fine for a few days after I worked out some bugs until the speaker started freaking out this morning.
...
I have finally built my first saber using a Saberforge Epoch and nano biscotte v4. The saber works if I swing it around but as soon as I duel with it, it acts up. I followed this wiring diagram. The...
I knew the LED posts mattered but I wasn't sure on the switch posts. I appreciate your help.
I know that on a regular switch without an LED, it doesn't matter which post you use for positive or negative. Is this also true for the switch posts on an AV switch?
That makes sense. Thank you for the help.
I got a GGW TRI Cree LED for my first build. How do I know which LED is the white one? And for in the future for color mixing, how would I know which LED is which color?
You nailed it. I don't want to dive into it and short out an expensive NBv3 board.
Hello there. This is my first time looking into doing my own installation but I know nothing about soldering and wiring components. It it possible to do a NBv3 install with 100% modular/prewired...