Very carefully check all the grounds for your LEDs and make absoultely sure they correspond to the correct channel.
Each LED needs to be connected to the same set of positive and negative pads, or...
Type: Posts; User: Skottsaber
Very carefully check all the grounds for your LEDs and make absoultely sure they correspond to the correct channel.
Each LED needs to be connected to the same set of positive and negative pads, or...
I have gone through numerous customs (South Africa, England, France, USA) with two sabers in my hand luggage and haven't had any problems. When officials have asked about my bags I have simply...
I think it was a misinterpretation of what I posted above:
With the exception of the batteries which I don't know about, all electronics can easily survive a spell in a household freezer (usually a minimum of -23°C, they tend to be rated to temperatures of...
Those pins are the programming port pins for the PIC microcontroller. They serve no function to the consumer.
I might add that soundboards are not simply circuits that you connect together. I could give you a schematic for a working soundboard right now, and you could buy all the parts and connect them up...
I'm hopefully going to order the last few parts I need for my latest saber in the sale.
Sure, if you only want 20mA going to your FoC LED :p
The DynaOhm in the store is the same as the current regulator on Petit Crouton, it varies voltage to give the specified current to the LED it is...
The MHS system has a limited (although admittedly large) number of combinations. It's not unreasonable to think that two people would come up with similar ideas.
A shame it's only a Petit Crouton. I love ResBlade with pitch shifting ramped up super high.
Looking through my font CDs yields the following list:
Elemental - H2O
Nano Deus Tachi
Phoenix Pyre
Steel Sword
ResBlade
Chain Whip
Iron Inferno
Hope that helps ;)
It's similar to how when you actuate a switch, the plunger pushes two conductive plates together to make an electrical contact between them, allowing electricity to flow.
In a recharge port, there...
This seems to be the right idea. If I were using using multiple sabers at once with multiple swap in batteries (for a saber combat/cosplay group, I presume?) I would have the individual protected...
Are you sure your SD card holder is not shorting out on your hilt somewhere?
It doesn't look like any of the concept art or the in game models from SWTOR. Possibly something from the Jedi Knight games.
Hadn't checked this out in a while - last I had heard he was running into issues with LFL and had to stop the project. Nice to see it's off the ground (so to speak :p ).
There are a couple of us still playing on The Harbinger, however the majority of the original players moved to different servers for a reason unknown to me.
Cordaroyfog & I still play on a near...
You have power (watts) and resistance mixed up. You can go over power without adverse results, but changing the resistance will make your LED either brighter or dimmer.
The formula for calculating...
Signaling in firmware for CF is almost definitely the switch pin set as a digital input waiting for a logic level low (with a pullup resistor on the pin enabled internally in firmware to prevent the...
From the internal diagram it appears that it switches OUT to positive. I believe that you need to connect VCC to the 3.3V pad, GND to one of the small signal ground spots, and OUT to the switch pad....
Very few MMOs for PC are published for consoles, due to their complexity (consoles don't have nearly as many buttons as a keyboard, for instance). It would be published for macintosh before consoles,...
That schematic looks fine to me ;)
There are add on boards that can accomplish this effect for you. A forum search may reveal more, or email me.
/mysterious
I'm going to be there :D
It sounds like the board is underpowered. It sounds like your power supply is getting enough voltage to the board, but not enough current. Most 12V DC adapters are made for charging consumer...