So, I don't have a "standard" momentary switch on hand, so I just disconnected the switch. I then directly bridged the accent pad to the black wire that is tied into the white wire that goes from the...
Type: Posts; User: TheMohawkNinja
So, I don't have a "standard" momentary switch on hand, so I just disconnected the switch. I then directly bridged the accent pad to the black wire that is tied into the white wire that goes from the...
It's not supposed to be pretty, as it's just making sure that I actually know what I'm doing.
I'm not sure what you mean by activation negative. If you mean the common pin of the switch, that's...
Yes.
I did, there's an Imgur link in the OP.
Hello,
I recently soldered up a Nano Bisc V4 to make sure everything is wired correctly. On the first power on, everything worked fine (power up sound when removing kill key, and LED+sound when...
So, have you talked to this "Zook" person yet by chance? I have yet to get a PM or anything.
Awesome, I wouldn't of even thought that would have been economically feasible.
I don't know how, but upon closer inspection, I have in-fact wired the board in reverse.
I have now corrected the issue, and upon pressing the activation switch, I get no sound, the switch LED...
Yes, each other. I powered on the board and had those wires touch each other when they were only soldered on the board pads and nothing else. Touching the wires together did not appear to affect the...
What do you mean by a "real momentary switch"? I thought a momentary switch is defined as a switch which (if in normally open state) will close only while the switch is held down, or (if in normally...
https://imgur.com/a/wQRk3zO
I would like to note that (A) I have a known latching switch from the same manufacturer, and it clearly functions mechanically differently (the known latching switch...
It is a momentary switch.
Here's a few to start out with: https://imgur.com/a/ueOYKBJ
Let me know if there are any other pics you want.
Thank you,
Right, but I've already confirmed that no bridge exists on the pads, and I haven't added solder to any other part of the board, so I am unsure of what traces and/or chip pins need tested to determine...
Hello,
So, the wiring layout, issue, and troubleshooting steps that have been taken can be found on a Reddit thread here:...
I chose the eBay one, because it is a "proud" switch (that is, the button is above the outer ring) which makes it a lot easier to use IMO. I can do some more research and see if I can't find a...
So, would this be more correct as far as the negative wiring and resistances is concerned?
https://preview.ibb.co/b6nhPU/Wiring_diagram.png
As for the use of a momentary switch, why does the type...
Awesome, okay that makes perfect sense. Does the rest of the layout I have seem good?
Hello,
Finally got all the parts to start soldering, but I would like someone to double-check by (definitely not technical, but I'm learning how to fix that) wiring diagram.
The switch is from...