if you have issues later an hour in the freezer helps as well
Type: Posts; User: jjshumpert
if you have issues later an hour in the freezer helps as well
im well over 20 grand, with over 3 grand in my personal hilts
nova i have had the 2010 boards run on single 18650's, 2x18650's, 4.8 nihm AAA packs, and the 6v AA holder running 2500mah nihm cells. i havent metered the board outputs, but i cant tell much...
i love the look of this one fb, great design and you really pulled off the hard used look, im really impressed with this one buddy!
well like i said, i have an mr board running a p4 red, in fact im holding onto it as im typing this, and with it running it is warm, but the bh and heat sink takes care of that just fine. and i have...
yeah they all do that buddy, thats what the heat sink is for :D
if it is the thicker body, just sand the inside of the hilt until the blade holder slides into place. when mr was putting these hilts out we had the same trouble, although the hilts had the removable...
i have a vader on the bench that has been running a p4 red for over a year with no issue
the only differences found in the ani hilts are some where of a thicker hilt body material that needs to be sanded to allow the conversion to fit. tims kit works for the hasbro anakins no problem
no need for resistors with mr boards, think of it as a buckpuck with sound
18650 is roughly twice the size of AA
with a little chasis rework 4 1000mah AAA's will fit in place of your 18650 no problem
dont get one of the grand rapids international products ones in the orange casing, they die in a matter of months
i cut the saber emitter on either side, pretty much no other way to get the saber apart otherwise. you can still put it back together and play with it.
good deal, any idea when this might make it to the store? i need 3 sets :D
the endors dont work because the dies are towards the outside of the star, but there are triple die stars that the emitters are close to the center of the star that are usable. there are optics for...
heres a question for ya tim, in use of these couplers with sound saber do you think we will have to use a reverse sound setup? im just looking at the design and it doesnt seem like sound ports in...
if you look closely at the board all the required connections are labeled beside the pads
no worry of the self etch damaging your hilt, i use it all the time when painting cars. basically what it does it eats away any impurities on the surface of the metal. just make sure you use it...
i bend back the connection to the board negatives and solder it directly to the board
ive heard of the 2010 boards having different fonts, but i havent had much experience with this as i only use the vader boards
looks good, which econ board will you be using in this hilt?
another great saber! and i was really impressed with your connections between the sound/crystal chamber module and your lux module, a simple and well conceived system. this time im going to have to...
yup your led + should come off the vdd that your clash is hooked up to
not if you charged em yesterday... mind uploading a pic of your wiring diagram?