https://youtu.be/20Lfh3B2SQ4
Various parts in this video will be coming to the store soon.
Type: Posts; User: Madcow
https://youtu.be/20Lfh3B2SQ4
Various parts in this video will be coming to the store soon.
Crystal chassis:
https://youtu.be/a7zEYAuvGZc
Control Box:
https://youtu.be/pJyKSB8Nlo4
A quick rundown of how to wire the PCBs
https://youtu.be/Bt-YkXnwt28
For the perfect fit.
https://youtu.be/MLhCloMy_JI
With the v6 speaker holder
https://youtu.be/oGdwJqifXqE
Possibly, I'll add it to the list. You can also get some good feedback vibration from the 2w speaker.
Definitely planning this already
I was recently sent this question...
"Hey Rob, I was watching your videos and noticed on the "Pommels Inserts and Clips" you showed an insert with the recharge port in the pommel.
Which speaker...
Quick glance - looks OK to me other than the aforementioned switch LED resistor.
If you find the blue is not as bright as you expect - try the same .5 ohm resistor as you have on the green
New video outlining the basics of an evenly lit blade:
https://youtu.be/5pKYeFxqENU
Showing how to use R.I.C.E with your Plecter Labs saber:
https://youtu.be/yQG126pvhrI
Yes - you wire the FoC LEC (-) there, but if you bridge those pads you'll need to place your resistor elsewhere on that circuit.
Whenever you change the volume of a sound file you risk altering a number of things. Perhaps the zero crossings at the beginning and end of each file get altered. I would check those too.
I would run them in parallel off the same accent LED pad
Those claws I machined from 1/4" flat T6 aluminum
Some have asked for this. It's a breakdown of how to wire in a RGB accent LED and use the CF8's features to light a crystal.
The 5mm RGB accent LED will be available in the store soon.
...
I did that here:
https://youtu.be/H9moBORo47A
Works great.
LED 1 is the low side, LED 8 is the high/full side.
It's also possible that if your soldering iron is too hot, or if you heat the contact for too long... the LED becomes un-soldered inside the switch. That happened once to me.
How to secure a pommel insert with the clip
https://youtu.be/2nMjz-19HzA
Good ideas - thanks
Here... at about 6:40
https://youtu.be/XOWnNJE3dRA?list=PLBZx-DMVqx7druzwlBkXoZZhd30_0LXNS
Agreed - a drill press can get a perfect hole and then the tap will likely be straight as well.
Use a punch to get a starting point for your drill bit to keep it from "walking" and not going in...
Simply use the accent LED pads as described in the manual. There is a different setting in each of the files for idle, for lockup, and for during blade action (in the led.txt)
Premium speaker right?
Try starting up the saber then while it's running, gently press the black surface of the speaker and see if sound returns temporarily while you press. If it does it's a blown...