Yeah it works better wired the way I had it in my diagram. I put on March firmware on the CFX and should be using the matching RICE software, but it...
I had to shave down a micro usb cable to make it fit, but no dice, unfortunately I don't have anything else that has data and micro to test the cable...
Tried the software and no go, swapped the wires but that seems to be worse, now on CFX.exe the error is Could not connect to Lightsaber. Please reset...
I'll try the software Thanks.
With the ground at the top I used the left post as TX and right as RX, not sure if I wired them backwards though to be...
So the ones directly on the sides are the LED posts? Ah okay now that makes more sense, i thought the two bigger ones would be for the switch itself....
You could try using my calculating resistance guide (link in my signature) to figure out which resistor you will need. As long as you’re using one of...