I am new to this hobby.
I will start gathering parts for my budget Graflex build.
I will not use any 3D printed chassis, no crystal, no in-hilt recharge port.
Since I live outside the US, it is difficult for me to obtain some of the parts.
My primary source of material will be TCSS.
Your input will be greatly appreciated!
My Parts List
Name Shop Order Delivered Parks Saber Graflex 2.0 kit Parks Saber 2017/02/17 2017/05/29 Graflex 2.0 1" blade holder TCSS 2017/02/20 2017/05/23 SPST Momentary tactile switch TCSS 2017/02/20 2017/05/23 Heatsink module for 1" ID tubes with center hole TCSS 2017/02/20 2017/05/23 8-32 x 1/8" Set screw TCSS 2017/02/20 2017/05/23 Set of 4 short Graflex style electrical pins TCSS 2017/02/20 2017/05/23 18deg Tri-Rebel/Cree Star Lens TCSS 2017/02/24 2017/06/01 Blue/Blue/White Cree XP-E2 CopperNova TCSS 2017/02/24 2017/06/01 18650 Single Cell Holder TCSS 2017/02/24 2017/06/01 MHS speaker mount V6 - For 28mm Speakers TCSS 2017/02/24 2017/06/01 1ohm 2w resistor TCSS 2017/02/24 2017/06/01 2W 28mm Bass Speaker TCSS 2017/02/24 2017/06/01 KEEPPOWER 3400mAh 18650 battery Amazon Japan 2017/02/27 2017/03/01 Nano Biscotte Sound Module V3 TCSS 2017/02/27 2017/03/13 "TCSS style" Battle blade 1" OD (36 inches) TCSS 2017/02/27 2017/03/13
My bottom chassis will be MHS speaker mount V6.
I'll use TCSS 1" blade holder and use the switch that is included in 2.0 kit under the red button.
Please comment if I'm missing something. Thank you.
Bookmarks