Ok..who wants some powder coating done??

[Ram21]

I just put in for the MHS thin neck "choke point" section Extension to be given Wet Jet Black.
I can't wait to see what It looks like I will make sure to post as well!
thanks!

Just arrived Super Wet Black!
http://forums.thecustomsabershop.com...?t=4630&page=3

[37H4N]

Hey is there gonna be another shade of red? Like maroon or blood red or something darker than the red that Tim already has?
Sorry if it was mentioned in one form or another somewhere.

[Jak'Kan-Ur]

Just arrived Super Wet Black!
http://forums.thecustomsabershop.com...?t=4630&page=3

Yikes!!! That looks amazing.
I went with the Flat it fits my design and Era much more. But that looks just amazing and so true to the hilt.
Like the spots painted are perfect, really liking that hilt.

[Chowser]

Hey Tim, me again, my daughter just stole a ribbed piece from one of my MHS's for her own MHS (she wanted sound), so I'm going to send you an email about this:

MHSribbed in US blue, going to steal a pic from Ram21 to show what I'm asking.



Is it easier to do the inner grooves or the outer in addition to the part I circled?

Whatever is easiest for you, the look I'm going for will be the same.

Thanks,
Phil

here, like you did for your daughter's MHSribGroov section:

[Chowser]

And it's me again

You did this for me back in the day:
Shilt4 in US Blue


Is it possible to order

DF5

and have the grooves from Shilt4 cut into it (just some of the grooves) and a switch hole machined for the new switch10?

and of course, US blue powdercoating again

sample pic cut from above

[Strydur]

Sure its possible. Order the df5, PC, switch hole, and $10 custom work fee.

[One Skunk Todd]

Do you have any pictures of the psycho lime over top of the extreme chrome, or the brass or gold?

[Strydur]

I do not at this time.

[Jay-gon Jinn]

Powder coating adds enough that sink tubes would not fit. This could be made to work by machinging the part first and using a lighter coat maybe. The problem is if you dont put a thick coat then the part will have more of an orange peel look than smooth.

I hate resurrecting an old topic, but did anyone ever figure out how much has to be machined off to make a powder coated part fit inside a 22 ga. chrome sinktube?

[Sairon]

1.43 I think