dimensions

[ArkaiHalon]

Does anybody happen to know the dimensions of this
http://www.thecustomsabershop.com/MR...-kit-P273.aspx

[Er Dan Gill]

I happen to have one of those, my Obi is apart for upgrades, what dimensions do you need?

[ArkaiHalon]

sweet

Length and OD. Mainly will it fit in a 1.25 inch sink tube, witha little wiggle room? The normal 1.25 inch bladeholder is a little to big on OD for what I need, and this one looks like it might do the trick.

[Er Dan Gill]

It wont fit in a 1.25" sinktube (already tried) outside diameter is 1.23". Maybe if you had Tim machine the large area at the base down a bit, or are patient with sand paper
Length on it is 3.27" with out the heat sink installed, 4.05 with the heatsink, LED, and optics installed.