Results 1 to 4 of 4

Thread: set screw size question.

  1. 10-23-2007, 05:23 PM #1
    Hasid Lafre
    Hasid Lafre is offline
    Sith Lord Hasid Lafre's Avatar
    Join Date
    May 2007
    Location
    Nebraska
    Posts
    3,943

    Default set screw size question.

    Ok so I got this old ultra style bladeholder(thanks again C) and iam trying to figure out what size setscrew I can fit in these holes that go around the bladeholder.

    Now I can take this allen key I got and it fites in it and its kinda loose but not omg thats loose.

    The number key is 5/64. Whats your thoughts? and what size tap would I need?
    Reply With Quote Reply With Quote
  2. 10-23-2007, 06:50 PM #2
    vortextwist
    vortextwist is offline
    Jedi Council Member vortextwist's Avatar
    Join Date
    Nov 2006
    Location
    Nebraska
    Posts
    2,328
    Send a message via MSN to vortextwist

    Default

    just use a drill bit to see what size the hole is. geesh. you should know that. bring it by tomorrow.


    BLUE 3- Ready
    Reply With Quote Reply With Quote
  3. 10-24-2007, 09:04 AM #3
    Hasid Lafre
    Hasid Lafre is offline
    Sith Lord Hasid Lafre's Avatar
    Join Date
    May 2007
    Location
    Nebraska
    Posts
    3,943

    Default

    you have it.
    Reply With Quote Reply With Quote
  4. 10-24-2007, 01:40 PM #4
    vortextwist
    vortextwist is offline
    Jedi Council Member vortextwist's Avatar
    Join Date
    Nov 2006
    Location
    Nebraska
    Posts
    2,328
    Send a message via MSN to vortextwist

    Default

    i have the drill bit but not the tap. will have to see if work has one. we have the set screws also I beleive.


    BLUE 3- Ready
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules