PLI ignorance
I looked around but didn't see an answer to my question:
How do you wire the PLI if there is no sound board involved?
The store pic seems to show a connector terminating the wire lead......
want to work one into a design but don't know how to pull it off.
Any advice, how2s, or why4s welcome.....
Thanks
All things a beginning have.
As all things do an ending.
Be not too hasty from one to the other to move, or much will you miss, along the way.
Wire it independent of everything. To be accurate that's how it should be anyway.
Put the leads to the batteries and interrupt it with a switch of some sorts. I sucks juice always on so a momentary to just check would be ideal.
RED LEADER Standing by!
Even with a latching switch it would still pull when off?
If that is so I may re-think using one.
BUT,
It would be wired post switch to battery NEG and to Switch POS?
All things a beginning have.
As all things do an ending.
Be not too hasty from one to the other to move, or much will you miss, along the way.
No... I meant it constantly pulls power when you have it setup with a latching switch. It's small compared to a luxeon, but you're not looking at it all the time... why have it on all the time (when the saber is on that is)?
The rest I'm confused on... just take the red and black leads already on it, both go to the batteries. Then somewhere in the loop put a switch.
RED LEADER Standing by!
that's what I was thinking. Thanks.
All things a beginning have.
As all things do an ending.
Be not too hasty from one to the other to move, or much will you miss, along the way.
Posting Permissions
Reply With Quote
Bookmarks