Will it fit on a 1.5" sink tube?[/i]
Will it fit on a 1.5" sink tube?[/i]
If you are reading this sig, then please pay attention to the following statement:
The owner of this account is now using the name "Jacen_Aurion" sorry to confuse everyone but I'm no sith lord by any means.
I AM A JEDI!!!
oh, I forgot, if someone knows how long the claws are, that'd be helpful to know, if I can fit the claw mount onto my sink tube. (even though I don't have one, in the case that it does work with a 1.25" tube and doesn't with a 1.5" please let me know)
If you are reading this sig, then please pay attention to the following statement:
The owner of this account is now using the name "Jacen_Aurion" sorry to confuse everyone but I'm no sith lord by any means.
I AM A JEDI!!!
it will work on a 1.5 inch sink tube, but not on a 1.25
you might need to do a tiny bit of sanding, but i don't know for sure.
the claws are 3.25 inches long
Aluke123 on every other forum - Old grumpy moderator here
Thread Index, The Saber Building Dictionary, and The Basic Saber-Build Tutorial - Read Them!
thanks a ton! that's great news.
If you are reading this sig, then please pay attention to the following statement:
The owner of this account is now using the name "Jacen_Aurion" sorry to confuse everyone but I'm no sith lord by any means.
I AM A JEDI!!!
I think you might have it wrong maul. since the mount fits on the mhs it would be too small to fit on the l.5 sink tube.
BLUE 3- Ready
the mhs is 1.45 diameter, so you'll need to sand off 5 hundredths of a inch on the sinktube.
vortex, that's why i said you'll need to do a tiny bit of sanding
Aluke123 on every other forum - Old grumpy moderator here
Thread Index, The Saber Building Dictionary, and The Basic Saber-Build Tutorial - Read Them!
yes I realize this but if a sinktube will slide over the mhs, that is alot of sanding. maybe if he used the sinktube adapter and an blade holder he won't have any problems.
BLUE 3- Ready
lol... think about it harder.
To slide sinktubes over the MHS it is 1.45" OD ... The Claw fits over the MHS snuggly ... Thus the ID of a sinktube is 1.45".
That's a lot of sanding... easier done by cutting off the tube!
If he uses an MHS emitter and adapter it will work though. He would just have to have more of the emitter outside the tube to give the claws a mounting place.
RED LEADER Standing by!
what i'm planning on doing is sticking the mound on the bottom end of my saber, and then mount the claws pointing upward.
If you are reading this sig, then please pay attention to the following statement:
The owner of this account is now using the name "Jacen_Aurion" sorry to confuse everyone but I'm no sith lord by any means.
I AM A JEDI!!!
You'd be best served doing that via the MHS to sinktube adapter, leaving it out of the sinktube just a little bit, then mounting the claw mount to it. You get a bonus by having a threaded part to screw a pommel into.
Bookmarks