Originally Posted by
RavenXp
It does look like you have what you need, aside from the proffieboard (TCSS now carries the v3.9 board which does have some advantages, but it does cost more than the 2.2). As for resistors, the only ones needed would be for extra data lines. There is a built in one for the Data1 pin, but Data2-4 would require a 470 Ohm Resistor (this is for cleaning the data signal). Another tip I should pass along is you will need to make sure the battery being used is high drain, at least 10A concurrent discharge rated (TCSS sells 15A ones that are perfect). And only single cell, so 3.7v. Thankfully the power lines feeding to the blade strips do not need resistors.
Bookmarks