-
Hasbro wiring issue
Hello there. I have a 2010 sound card from a bladebuilders darth Vader but for some reason if I connect the 5w led to a positive and the negative to the led neg on the board, the 5w led comes on very dim. With or without the lightsaber on. But the led fitted to the board works as it should running with the std 3 aaa setup 4.5v is there a problem with the board or is there a way to get round this.thank you
Last edited by Coz; 01-01-2022 at 07:33 AM.
Reason: Added photo
-
you need a PNP transistor because the forward voltage on a high emitter LED is more than Stock led on the board
https://youtu.be/JBlBTadrOQM
Here is a good video tutorial on how to wire the transistor and LED. You might even want to get a micropuck or buckpack if you don’t want to use a resistor on the LED.
Befor/after wiring images from the same YouTube video.
https://i.imgur.com/1eBMPkr_d.webp?m...idelity=medium
https://i.imgur.com/woaYS84_d.webp?m...idelity=medium
Hope this help if you’re still stuck
Last edited by Chefbobbert; 05-14-2022 at 03:07 PM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks