-
Board Lurker
How do I get it to fit if it’s female on both sides, also w/ the buttons taking up half the hilt diameter do I just need to be extra careful with planning where my wires go around it?
-
For a normal HP LED setup, there should be enough clearance around the AV switches in the hilt to get to the emitter. and the shop has adapters, either a double male or gender changer, look under Adapters in the MHSv1 section.
-
Just an FYI, that LED module is not correct, it is for 1-in diameter tubes...not MHS parts.
You need this one: https://www.thecustomsabershop.com/M...ink--P841.aspx
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks