Well with lack of any contrary opinions, I proceeded with the wiring/install.
I have not done anything with the cards and settings yet. Wanted to make sure the circuit all works first.
I bought a Vader Vault pixel blade to be run by the Prizm 5.5 board.
I used this wiring diagram as a guide.
circuit.jpg
I connected the battery and got a boot sound but a cyclical beep due to not changing the settings on the latching switch yet so acted like I was continually pressing the button I guess. I did not get any ignition of the blade though.
I need help please!!
1. Does the Prizm 5.5 require the pads to be bridged next to the LS data line? Wasn't sure if this was a change between the 5.1 and 5.5.
2. Does it matter which of the two negative lines connect to L2/L1 or L1/L2?
Finally 3. Am I posting for help in the right place or forum or is there a better resource to ask?
Appreciate any help.
Bookmarks