-
Upgrade Sensors on New Bladebuilders Board
I just got two of the new Bladebuilders board as seen in this thread: http://forums.thecustomsabershop.com...ear-Down-Guide
I was planning on upgrading the clash and swing sensors, but am confused by what looks like to be two swing sensors and a clash sensor on the board. Does anyone know which parts correspond to these marks on the board?
F1
C1
SW3
SW2
Thanks!
-
Board Lurker
C1 is a capacitor. F1 is a fuse. SW2 is the clash sensor. SW3 is the swing sensor, to replace this you must wire one end to the 3rd pin with is sepearted from the first two and the other end to the nearest pin to the 3rd one. I recommend using the dual sensor set up where you connect two sensors in an L shape and wire it in as one omnidirectional sensor.
Last edited by Sixo; 02-20-2018 at 12:44 PM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks