Re: "Main switch led wired to main positive and negative to board"

The activation switch should be wired to the activation switch ("ACT") spot on the board. I'm guessing, but, perhaps the PRIZM isn't getting the signal to turn on the main LEDs. It requires an interrupted circuit, either normally on and clicked off or vice versa. You will also need to wire up a second momentary switch, the auxiliary switch.

Also, do you have resistors on the negative wires between the PRIZM and the LEDs? If not, you may have fried the LEDS.

Sorry I'm giving you info that you already know.

HapKi