Hello everyone! This will be my very first build! This is what I have so far.
- MHSV1 Blade Holder Style 1
- 8-32 x 3/8" Stainless Steel thumb screw
- Hilt style 2 (Machine recessed 16mm AV switch hole)
- Pommel style 3
- MPS Insert style 11
- Rebel Star LED & MHSV1 Heatsink Module (Luxeon Rebel Star (Deep Red) / Heat Sink V3 (Long Style))
- BuckPuck 700mA 4-wire
- 7.4v Li-ion 1050mAh 14650 Battery Pack
- Push on/push off switch with black button
- Black rubber switch boot
- "Corbin style" Show blade 1" OD (40 inches / Double Wrap / Bullet Shaped)
- 16mm Anti Vandal Latching Red Ring Switch
I want to make sure everything was going to work together.
Thank you everyone in advance!
*** a couple of Answers to Questions I'm sure will be asked! ***
Do I know what I'm doing?
No, I am a quick learner though, and I looked around some of the beginers threads.
Have I built a lot of things?
Yes, Including working with lots of metal.
Have I worked with electronics/soldering?
A little bit, mostly just repairing things though, and I have never worked with LEDs.
Am I aware that 40" is a VERY long blade?
Yes, I'm a tall guy, and I'm strong, and I just think it would look super cool.
What do I want to do with this saber?
Keep it in my apartment and enjoy looking at (and swinging around) something I built.
Thanks again for any help or advice!
- Lazer
Bookmarks