I built my first saber with sound!
I'm using nano biscoutte v3, Cree r/g/b - purple with green Foc,
Problem: everything was working as it should... Then I noticed the blue and red began alternating intensity. It started switching between purple and magenta. Then when the saber was turned off red led still output light.
I'm using a wiring harness. I trouble shot and narrowed it down to a problem between the blue wire/L- and the negative battery input(just left of it). (I ripped all the wires out of harness and soldered on back.
The only thing I can assume is that solder may be touching on the top side. I checked all wiring connections.
Any suggestions?
Any idea on how to remove harness plug after it was soldered?
Bookmarks