Results 1 to 7 of 7

Thread: Powder Coating and Tolerances...

  1. #1

    Default Powder Coating and Tolerances...

    I'm looking to have a shroud custom machined, and if Tim is unable to do the work when the time comes, I'm going to have to go to another machinist. With that in mind, I'm faced with a slight problem. The shroud will need to fit over a powder coated saber, and will need to be powder coated on the inside to get the look I'm going for. So, how much extra inner diameter do I need to give to allow for the two layers of powder coat?

  2. #2

    Default

    Depends on the powder coating. The translucent PC coatings tend to be thinner than the textured or matte finish ones.
    We all have to start somewhere. The journey is all the more impressive by our humble beginnings.

    http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
    http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!

  3. #3

    Default

    Most likely matte black and brilliant bronze on the inner hilt, and trans purple on the shroud

  4. #4

    Default

    finding someone to anodize the inside instead of doing a PC would solve your problem

  5. #5

    Default

    That's an interesting idea. Can you powder coat over anodizing? I could just get the whole shroud anodized, then slap a clear coat on the outside for protection...

  6. #6
    Sith Warrior darth_chasm's Avatar
    Join Date
    May 2015
    Location
    United States
    Posts
    1,754
    Blog Entries
    2

    Default

    I would do one or the other if you want colors to match. You can anodize at home in a fairly clean and safe way. I just finished anodizing my most recent build.

  7. #7

    Default

    You can powder coat over anodizing. Anodizing is pretty durable, so clear coat may not be necessary (though it won't hurt anything). Keep in mind that anodizing does increase the size of parts by a very small amount. That usually doesn't come into play unless your tolerances are *very* tight though.
    We all have to start somewhere. The journey is all the more impressive by our humble beginnings.

    http://led.linear1.org/1led.wiz for the lazy man's resistor calculator!
    http://forums.thecustomsabershop.com...e-to-Ohm-s-Law for getting resistor values the right way!

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •