Hi everyone. I'm wanting to build my own saber. These are the parts that I have so far. I have most of the body pieces figured out, I just need help with the electronics.
Hilt Pieces:
http://www.thecustomsabershop.com/MH...e-17-P417.aspx
http://www.thecustomsabershop.com/MH...le-3-P762.aspx
http://www.thecustomsabershop.com/Hi...ctor-P126.aspx
http://www.thecustomsabershop.com/MP...le-1-P175.aspx
http://www.thecustomsabershop.com/Ac...le-6-P569.aspx
http://www.thecustomsabershop.com/Ma...clip-P161.aspx
Misc Parts:
http://www.thecustomsabershop.com/MP...le-1-P262.aspx
http://www.thecustomsabershop.com/MPS-Clip-P72.aspx
http://www.thecustomsabershop.com/6-...rew--P169.aspx 4x (In case I lose one)
http://www.thecustomsabershop.com/8-...crew-P546.aspx
http://www.thecustomsabershop.com/8-...head-P107.aspx 2x (In case I loose one)
http://www.thecustomsabershop.com/24...pool-P737.aspx 2x (One blue one white)
http://www.thecustomsabershop.com/18...ubing-P32.aspx 2'
Electronic Parts:
http://www.thecustomsabershop.com/Re...dule-P653.aspx
http://www.thecustomsabershop.com/16...itch-P429.aspx
http://www.thecustomsabershop.com/20...stor-P847.aspx
http://www.thecustomsabershop.com/Pa...tery-P853.aspx
Services:
http://www.thecustomsabershop.com/Dr...Hole-P193.aspx 2x (One for the blade holder and one for the covertec button)
http://www.thecustomsabershop.com/Bo...vice-P572.aspx
Service Notes:
This is for the Box Mounting- "Centered at 1.875" from the end of the Hilt Style 1 (7"Double female threaded connector) on the side that will connect to the blade holder." Edited with better instructions.
This is for the Drill & Tap Holes- "First one will be on the blade holder. I would like this to line up with the Box mounting service in this order. The second on will be on the Hilt Style 1 (7" Double female threaded connector). It will be on the opposite side of the hilt than box mounting. This will on the back of the underside of the hilt. So on the 'front' of the saber is the box mounting and the blade holder screw. On the 'back' of the saber is the second drill and tap hole for a covertec button."
What I was needing help with is figuring out what size battery pack I need. How much wire/shrink tube I should get. As well as any resistors I might need. Also I want to know if I need to reword my service notes. I tried to be as descriptive as I could.
Thanks so much,
Nathan
EDIT: Changed a few things based on advice, and added a few things.
Bookmarks