Hi! This is the parts list to my first 2 sabers that I'll hope to be making soon.
Saber 1:
MPS Pommel Style 4 (1)
MPS Insert Style 4 (1)
MPS Clip (1)
Hilt Style 1 with Standard switch hole (1)
LED blade holder style 9 (1)
Drill and Tap hole, 8-32, for the blade holder (1)
Build Your Own Seoul P4 Electronics Kit (red) (1)
MHS 'new style' Heat sink v2 (1)
Star Thermal Tape pad (1)
LED ‘Corbin Style’ Battle Blade 1” OD (36”) (1)
8-32 x .3" red thumb screw (for blade retention) (1)
Saber 2:
MPS Pommel Style 8 (1)
MPS Clip (1)
MPS Insert Style 7 (1)
4 inch Fluted Double Female Connector (1)
Drill and Tap hole, 8-32, for Covertec on connector(1)
MHS Choke style 3 (1)
Double threaded male threaded connector style 1 (1)
2 inch double female threaded connector (1)
Machine recessed AV switch hole for the connector (1)
LED blade holder style 12 (1)
Drill and Tap hole, 8-32, for blade retention (1)
Covertec clip (1)
16mm Anti Vandal Momentary Gold Plated Switch (1)
Rebel Star LED & MHS Heatsink Module (Royal Blue) (1)
2.2 ohm 5w resistor (1)
4AA battery Holder (1)
8-32 x 3/8" socket head (for Covertec) (1)
8-32 x .3" Gold Thumb screw (1)
LED 'Corbin Style Battle Blade 1" OD (36") (1)
Stuff for both sabers:
1/8” Adhesive lined heatshrink tubing (2)
Dual 24 gauge wire (sold by the foot) (5)
Super Lube Synthetic Grease (3)
Did I forget anything? Also, what is the difference between a Latching and Momentary switch, and between the Corbin and TCSS style blades? Thanks a lot, and any suggestions are welcome
EDIT: Just found a thread about the different types of switches, changing my design now. Do either size of AV switches fit nicely into either style of the basic hilt design holes?
Bookmarks