Hi all,
Finishing up my parts list and want to make sure I did the math right.
I'm going to be using a Tri-Rebel BBW with a PC2 and plan on using the white die for the FOC.
So paired with a PC2 and 14650 7.4V li-ions, I'll wire the two blue dies in series, then take the white die off the FOC pad, thru the power extender with a 3.9ohm 5w resistor from the store here put on.
And then in hte PC's configs I'm leaving the LED current setting at 1000mA and the FOC strength setting at 1000 also. I admit I am confused as to the purpose of the FOC Strength setting on the RICE panel and PC config. The manual just describes this as "strength" from 0-511, but the new version of the configs go up to 1023? No idea whats that about?
So anyway, wanted to double check and run this by you all in the hopes I won't blow anything up, burn anything out, waste power or have a pathetically dim blade.
Thanks in advance. I know it seems a basic question, but my degree was in fluid flow not electrical
Bookmarks