-
About Anti Vandal switches
I never had anyone give me a satisfying answer too this question, so on Anti vandal switches (illuminated ones) there is NC 1, No 1 and C1 for Normally close, Normally open and C1 for other connection and ofc the is + and - pole that goes into the main circuit but there is my question, how do i wire these Nc1, No1 and C1 into the circuit i mean, where is their spot in the circuit drawing, i have a resistor setup with just a led for the blade and this switch and resistors with this and 6v battery setup, so how are these wired then ?
-
Jedi Initiate
Look at this http://forums.thecustomsabershop.com...+switch+wiring
Have a look at the first diagram, the red and black switch is where your illuminated switch go (no1 and c1, or nc1 and c1), note that your + and - switch pads go to your main led (with the appropriate led resistor of course). I think it will be fine.
And btw, it took me half a minute to find this topic with the browser...
-
Many thanks for all the help you been giving, now rise of this Sith will start... as soon as the ship full of wookies apparently.. is arriving here too Sweden
-
Jedi Initiate
Your welcome from hoth (yes France looks like hoth or sweden these days with this all this snow)
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks