Okay, this is my third sink tube Graflex replica in a row. I seem to be stuck in a rut
This one is for a staff member who helped me land an NSF grant last year. Built from a 20 gauge sink tube using my modified Ant's graflex replica patterns. The clamp is scratch built aluminum, as are the "bunny ears". The blade holder is the first one produced on my "new" WWII-era Craftsman lathe. TCSS-supplied Seoul blue, short pins, textured clamp tape, swing sensors, clash sensor, and heat sink. Button, glass eye, and calculator bubble strip came from somewhere else on the web. It uses one of the new LED ladder Hasbro soundboards (a Vader) with no BuckPuck nor resistors. The "on" is almost instant, but the "off" has a nice dim-down effect with this board.
IMG_0245 by Orthus, on Flickr
IMG_0246 by Orthus, on Flickr
IMG_0247 by Orthus, on Flickr
IMG_0248 by Orthus, on Flickr
IMG_0249 by Orthus, on Flickr
IMG_0251 by Orthus, on Flickr
IMG_0252 by Orthus, on Flickr
IMG_0253 by Orthus, on Flickr
IMG_0254 by Orthus, on Flickr
Bookmarks