-
New revised parts list for econo based saber. Feedback greatly needed
Hilt style 4 with guarded style switch hole
Screw on LED blade holder style 18 "new style"
8-32 x 3/8" aluminum thumb screw
MPS Pommel style 3 v2
MPS Insert style 6
MHS choke style 1 short
MHS "new style" Heat Sink
Main Body Powder Coating (Jollipop Copper Orange ) (SH42)
Blade Holder Powder Coating (Jollipop Copper Orange) (B182)
Luxeon Rebel Lens Holder
Luxeon Collimator Lens 8.7 deg viewing angle
Luxeon Rebel Star (Red-Orange)
Drill & Tap Hole (x2, for blade and covertec clip) (8-32)
2AA Battery holder 7.2v (will hold 2, Li-Ion 14500)
BuckPuck 700mA 4-wire
SPST Momentary Guarded switch with silver button
Machined button for Covertec clip
5v Regulator
PNP Transistor (TIP42G)
LED Trans White Show blade 1" OD (32 inches)
Obi-Wan econonmy toy lightsaber soudboard
Using this diagram, http://i416.photobucket.com/albums/p...01-10-2011.png, I plan on using the buckpuck in replacement of the resistor.
-
Don't forget the mps clip
Also an interesting note I'm not sure if you have this exactly in your econo board but the Vader one I recently used had a separate board for driving the original 3 led's I plucked 2 of them out and soldered wires to 2 accent Led's
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks