i'm working on mounting my custom control box as well as bunny ears to my emitter shroud.
as i used to build computers for people, i have a bunch of micro screws used for things like hard drives, motherboards, etc.
i'm not positive the threading size, but i know they're less than 4-40.
i'm assuming 2-56.
these are the perfect size to mount both the bunny ears as well as the control box. i think 4-40 would end up being a tiny bit too large.
i have a couple questions:
1. how would i go about finding the threading size for these?
2. are there places locally that would sell a tap this small? i went to lowe's on my lunch break and it looked like the smallest tap they had was 4-40.
i couldn't find an employee who was free to ask them if they could special order something like this for me. and i didn't have the screw with me to check if they could size it or something?
if i had to eyeball it, it'd be extremely similar to these hex screws VV used on their starkiller:
Bookmarks