I got 2 700ma buckpucks that I need wired together. I'm just not sure how. Should they be run in parallel or series?
Thanks.
I got 2 700ma buckpucks that I need wired together. I'm just not sure how. Should they be run in parallel or series?
Thanks.
Last edited by Maurnick; 08-14-2011 at 09:57 PM.
The first question is Why? What are you planning on doing with two of them together? We need some more information fist.
Knowledge must be balanced by Practice.
Practice must be balanced by Experience.
Through Knowledge, Practice, and Experience
we gain Wisdom.
-Boj-Vaati Mau
Jedi Sentinel, Jar'Kai practitioner,
and Instctor at Strafe Plains Temple
Saber Guild: Strafe Plains Temple
The Rebel Legion
The led I'm using is rated at 1500ma. I figured 1 700 puck is too little. Two 1000s or a 700 and 1000 are too much. So two 700s are good enough. Wiring to a Sabersound board.
You need to wire them in parallel for 1400 mA.
In order to see the Light,
you must sometimes risk the Dark.
TCSS MODERATOR
BLUE 8 Ready to ROCK and ROLL!
Bookmarks