OK, maybe someone can explain this to me
7
Sooooooooo I slapped a meter on my VA Bane ('Resistorized Red' + 'Blue' on a DX RGB). I get 0.65 Amp with Sanyo Eneloops and 0.75 Amp with Energizer E2 Lithiums.
That didn't seem right, based on what was posted above, so I got out my RGB Prophecy (R,G,B with 3 direct drive toggle switches). I put a meter on that and i got:
Sanyo Eneloop 4.8V Nominal, 4.7V under one or two die load, 4.6V under three die load
Green die only = 0.50 Amp
Blue die only = 0.50 Amp
Red die only = 0.60 Amp
Green+Blue dies = 0.60 Amp
Red+Green dies = 0.70 Amp
Red+Blue dies = 0.70 Amp
Red+Green+Blue dies = 0.75 Amp
I was told that (by someone at the Ultrasabers forum) when you turn two on, it uses twice the current of a single die and if you turned 3 on, it uses three times the current of a single die. It doesn't appear that way...
I'm really at a loss here...
Bookmarks