ok so i don't need the resistor is that what you are saying....first time using rebels
ok so i don't need the resistor is that what you are saying....first time using rebels
![]()
Try not. Do or do not, there is no try.... Yoda
CLICK HERE FOR ALL YOUR ECONO SOUND BOARD WIRING DIAGRAM NEEDS!
THREAD INDEX
LDM's Basic Saber-build Step-by-Step Tutorial
Even with no resistor, a 3V battery pack is not enough voltage to properly power that LED.
In order to see the Light,
you must sometimes risk the Dark.
TCSS MODERATOR
BLUE 8 Ready to ROCK and ROLL!
ok so go up on my voltage got it ...thanks
![]()
Try not. Do or do not, there is no try.... Yoda
CLICK HERE FOR ALL YOUR ECONO SOUND BOARD WIRING DIAGRAM NEEDS!
THREAD INDEX
LDM's Basic Saber-build Step-by-Step Tutorial
Regarding the use of a resistor with the red P4, the store suggests using a 4.7 ohm/5 w resistor...but here I read to use a 2.2 ohm/5w resistor. Which resistor would be the better choice for use with the red P4? I wanted to do a LUX III conversion on my older MR saber (3 AA batteries putting out 4.5v) but since LUX III's are no longer to be found, I suppose I wil use the P4 but want the correct resistor.
if you're using an MR board, you'll have a constant 3.5V 1000-1200mA coming off of the LED wires on it. to cut that back to a level that won't explode your red P4, you need either a 1 ohm or 1.2 ohm resistor, depending on what your board output is (1000 or 1200mA).
Now known as Azmaria Dei
i really need "meow on clash" mya! =^_^=
duel - to fight someone 1 on 1
dual - 2 of something in line with each other
Yes...I do plan on using the origional MR board with my conversion. I'd hate to toast the P4 without the proper resistor.
Bookmarks