New MHS design

[cardcollector]

It's possible to drill through threads. I've done it dozens of times. Just make sure that before you drill, the parts screw together perfectly. If there's any tension, figure out where and file it down. Before you drill, get the parts dripping in WD-40 and screw them together TIGHTLY. Otherwise you could screw up the alignment. Drill, unscrew, and file away any burrs left by the bit. Good to go!

This is my daily dose of saber building Genius! Thanks LM.

[Onli-Won Kanomi]

Paint is all I have too but fortunately you can even design customized parts from MHS builder 'templates' using it.

I think that updated design looks really really nice and could certainly be upgraded to a lighted saber later at minimal cost.

Best of luck with it and MTFBWY.

[seelsa73]

Thanks for the feedback guys, and keep it coming

I'm not sure if i really like where the red acetal thumb screw is in the updated design...just because i feel like the neck of any lightsaber should be left alone, having something there just looks strange to me. I don't know maybe i just dont know what im talking about