The old Hasbro wiring diagram thread has become too full of comments to really clean, so I'm starting a new one. This thread will remain locked. If you have a diagram that you want put in, PM me with the diagram. In addition to the diagram, please provide as much detail as possible about what saber the diagram came from. Hasbro has tons of sabers out there, we need specifics! Also, make sure your diagram is good quality, not something with curved wire lines and a pixelated image.
To start, here are Tim's original ones. This is the kind of thing I'm looking for.
Let me start off by saying that this design is not approved by Corbin yet. I modified his drawing to show how to hook up his driver (the 3w driver I sell) and the hasbro sound modules I sell with only 1 momentary switch. I have tested this and it seems to work great but try it at your own risk. One nice side effect that I liked is that if you tap the switch very fast you can get just corbins driver to turn on for those times you dont want sound. Of course you need to tap it again without triggering the sound to set it back to normal. Only takes a minute to master but can be confusing. If you dont want the clash effect (which only seems to work some of the time) just dont hook up the 2 pink wires. I have only tested this with up to 6v and do not know if higher voltages will work.
Here is a 2 switch setup thanks to Cain.
This one was provided by GrimaOllak
Bookmarks