Yep, I'm at it again. To quote that Other Sci-Fi Property...
So here's the currently-named-until-I-change-it-again "Perseverance":
And the electronics engineer porn:
Parts list:
Blade Holder 14 (full copper & clearcoat PC)
Choke 2 (full copper & clearcoat PC)
MHS Gear (GER2 sun gold & clearcoat PC)
5" Fluted Double Female Connector (wet black PC in fluting)
MPS Pommel style 3 V2 (no PC)
MPS Insert style 1
Brass Covertec button
Red LED indicator
Slider switch
MHS sound/speaker/battery combo
Luxeon V Cyan
Quick disconnect
SPST momentary button, red
Switch bezel nut
Corbin Battle Blade, 36" thickwalled, quad-wrapped
Screws, resistor, wire, and other boring stuff that's implied
The button will be at the top of the fluted section, and the LED about an eighth of an inch below that. I'm 90% sure I can fit the MHS speaker/battery/US2 combo pack beneath them, with enough room to cram in the wires. The slider switch I'm looking at is here, and I plan to mount it to the back of the activation button, where it'll act as a kill switch for the whole thing. The LED will be wired as a power indicator.
Per guidance I've been given, I've opted for the Luxeon V cyan. I have one from Tim's last batch, so yay for me. I'm also considering getting the fluted section and pommel media blasted as well, but that's not definite by any means.
Bookmarks