Ok I just purchased a Dooko sabre from Walmart. I am Using the board and, hum and clash sensors.
1) The current set up requires x2 c batts. Would like to loose that without over loading the board or under powering.
2) The power or on off is actually located in the center of the board IE part of the bord much like a calculator.
I am goin to be using an LED plus a couple of others for small detail. Any suggestions as to how to go about wiring with the current switch. As I can not move it so evey thing will come on at once instead of using two switches? Or would it be best to just take this as a learing expierence and buy a diffrent set up. If the answer is buy a diffrent one what simple store bought should i go with IE Vader, Kenobi ETC. Thanks for the help. If you need pick or a Diagram will re post. Thanks alot.
Bookmarks