OK folks, I know some of you have to have done these at one point... How would one go about making a sink tube staff that breaks apart in the middle without having a bulky connector? every connector I've seen for joining two sinktubes basically consists of a thick ring that would make it very uncomfortable(and unsightly) to handle.
God knows, I'd rather just find a MHS solution, but the wife is already over boxes from Tim showing up (You spent $60 on that little box?)
So for now I'm going the cheap route(still from Tim, just cheaper) so if anyone could help me out I'd appreciate it.

P.S. My stripped down Vader/katana saber is now done! And as soon as my camera is fixed I'll have pics up... On that note if anyone wants the cosmetic Vader stuff(everything except the shroud) PM me with your address and I'll just send it to you. I have no need for it.