Good morning Sith and Jedi alike!

First saber build and I wanted to confirm the electronics setup. Below shows my parts list and an image I found from the Nano Biscotte sound board work mat. Is the image accurate for what I am wanting to build?

Thanks in advance for any help!

First Parts list:
1. Saber Forge Acolyte Hilt
2. Keystone Electronics Single Cell Holder
3. 18650 KeepPower 3500mAh Protected Button Top Battery
4. LED Heat sink
5. 2W 28mm Bass Speaker
6. Nano Biscotte Sound Module v4
7. 12mm Momentary Blue Ring Switch
8. Switchcraft 2.1mm Power Jack
9. x2 .47ohm .5w resistors
10. x1 1ohm 5w resistor
11. Star thermal tape pad - Tri LED
12. Blue/Blue/White Tri-Cree XP-E2 CopperNova
13. 18deg Tri-Rebel.Cree Star Lens
14. 28 gauge wire all around

From the image, I am looking at the bottom right instructions. Difference would be the image shows Red/Red/White. Mine is Blue/Blue/White.
https://www.jqsabers.com/product/nan...schematic-mat/